![]() I have no idea whether these programs are protected or not, but I'd suggest that you contact the source above for assistance, and there area number of PDF manual on that site that can be downloaded. sometimes one will work but not the other with no g-code changes. It seems to like G-code files ending in ".nc" or ".mmg" but I have no idea why, because you can take the same G-code and rename it one, or the other or both. ![]() Mine came up in English with the English version of ZHBDSPHandsetHost.exe, which is the SiGNTEK software. He says that the Chinese version will convert to English by pressing F10, but I'm not sure when. I would encourage you to contact Jery-Jiang at who may be the manufactuer of your DSP system. Actually, I wrote my own G-code, line by line in Notepad, out of frustration with the SIGNTEK software, and it ran fine. ![]() I entered a password, and the g-code loaded and ran. I took a chance and entered the "system" menu, and found a password menu (which the manual said wasn't active or available in the model DSP pendant that I had). ![]() After my first pendant had gone blank, and would not recover through repeated instructions from the factory, I swapped it out with the factory (shipping both ways was about $160). One of the cautions in the DSP manual is to stay away from the system settings, because the "factory setting" firmware may disappear. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |